Insulated Wire

Make out of any color Wool to get back that color of Insulated Wire. Color Wires are used to encode "color signals" inside Bundled Cable, and Different colored wires will not connect to each other. Used as a crafting ingredient for the Bundled Cable.

Bundled Cable

Stores 16 different color channels inside itself. Access them by placing that color Insulated Wire next to it. That signal can be accessed from anywhere inside the Bundled Cable.

Bus Converter

Shift-Right click with the Screwdriver to change conversion modes. In Analog to Digital, this converts a Redstone signal intensity 0-15 to its corresponding color frequency, for instance, 0 = White, 1 = Orange, 2 = Magenta, and so on. Digital to Analog Mode will check for the highest color active in the Bundled Cable and output a Redstone signal with that intensity. If there is at least 1 color activated then the side Outputs are energized as well.

Bus Input Panel

Presents a panel of 16 color buttons which you can then activate individually by hand and they will activate the corresponding color frequency in the Bundled Cable. If the Input recieves a Redstone signal the panel is reset.

Segment Display Gate

This is most useful when placed on a wall. Right-click with the Screwdriver to rotate and Shift-Right click to change the display type.

In Decimal mode, each segment links to a color frequency. 1-7 control the left digit, 9-15 controls the right, while 8 and 16 control the decimal points.

The other segment display mode can be used for displaying alphabet letters.

Right-click with a Dye to change the color of the display.

Bus Randomizer

When you place this on the ground, the sides are the Input, the side facing you is the Bundled Mask, and the side facing away from you is the Bundled Output. While any Input is active with a Redstone signal, the Bus Randomizer will continously randomize the Bundled Output. It will stop Randomizing when the Input is OFF. If the Bundled Mask has no channels active, the Bus Randomizer will use all channels. If the Bundled Mask has 1 or more channels active, the Bus Randomizer will only use those channels. Shift-Right click with the Screwdriver to change modes. In Exclusive Mode, the Bundled Output will only select 1 channel to Output at a time. In Non-Exclusive Mode, all channels selected will have a 50/50 chance of being on.