RedNet Cable is used to transfer a redstone signal. It can connect to Redstone Dust, and all redstone devices and machines that use a redstone signal. The signal strength is maintained constant from one end to the other. Right-click the RedNet Cable with the Precision Sledgehammer to switch between Standard mode and Cable-only mode, which only connects to other RedNet Cable.

This cable also has 16 color channels. When first placed, redstone signals go through the White channel by default. Use the Precision Sledgehammer and right-click the color band at the end of connections to cycle through the color channels. Shift right-click to cycle down color channels. The connected device will affect THAT color channel throughout the cable.

This is a decorative block, but is also used as a crafting ingredient for the Programmable RedNet Controller.

The PRC Owner's Manual is a Written Book that contains useful information and instructions for how to operate the Programmable RedNet Controller.

Use this and right-Click any RedNet Cable to display the signal strength of all color channels in the cable.

You can also right-click a Programmable RedNet Controller to check its variables.

Place this on a RedNet Cable and this will visually show you the strength of a redstone signal as a line gragh over the last few seconds. By default it shows the signal strength on the White Channel. Right-click with a dye to change what channel it monitors.

Used to copy the settings of a Programmable RedNet Controller to another Programmable RedNet Controller. Right-click the first RedNet Controller to copy the settings to the PRC Memory Card, then Right-click any Programmable RedNet Controllers after that to paste the settings. Put in a crafting table and craft itself to clear all data.